Compressor diagnosis & replacement
A unit that does not cool or repeatedly trips needs electrical and refrigeration diagnosis before condemning the compressor. We check the underlying cause, system condition and compatible replacement options; compressor replacement is quoted against whole-unit replacement where appropriate.
Ask about this repair →PCB & inverter control-board repair
Error codes, intermittent running or failed communication can involve wiring, sensors, power or boards. Board repairability is assessed; a replacement must match the model and revision, with any required configuration. An error code alone is not a board diagnosis.
Ask about this repair →Indoor blower & outdoor fan motors
Weak airflow, vibration and abnormal noise may involve a motor, blower wheel, bearing, mount or capacitor. We check the assembly and control signal before specifying a compatible motor. Cleaning and motor replacement are different work scopes.
Ask about this repair →Capacitors, contactors & electrical components
Starting faults or a fan that struggles to run can have several electrical causes. Components are tested and replacements matched to their electrical ratings. Customers should not open electrical panels or try capacitor tests themselves.
Ask about this repair →Thermostats, thermistors & sensors
Room temperature complaints may come from sensor placement, calibration, wiring or controller compatibility. Smart thermostat installation requires checking the control voltage and system interface; not every thermostat works with a VRF or inverter system.
Ask about this repair →Evaporator & condenser coils
Dirty, corroded or leaking coils require different treatment. We distinguish cleaning from leak repair and coil replacement, then check access and part availability. A compatible replacement is specified by the equipment model rather than physical appearance alone.
Ask about this repair →Drain lines, trays & condensate pumps
Indoor water leakage can involve a blockage, failed pump, cracked tray, installation slope or icing. We trace the cause and test the drainage after the work; a drain flush is not the right answer to every leak.
Ask about this repair →Refrigerant pipework, leaks & valves
Loss of refrigerant calls for leak investigation, an agreed repair and model-appropriate recommissioning. Refrigerant type and charge are checked against manufacturer requirements. Different refrigerants are not interchangeable.
Ask about this repair →Ducts, insulation, dampers & grilles
Room-to-room imbalance, air leakage and condensation can involve damaged insulation, a restricted return or poorly adjusted distribution. We inspect the airflow route and quote repairs or alterations separately from routine AC unit servicing.
Ask about this repair →Filters, remotes & louvre mechanisms
Replacement filters, remote controls and air-direction mechanisms must suit the model. Share the full unit label and photographs so the team can check the correct part and availability before committing to a replacement.
Ask about this repair →What an itemised repair quote should cover
- The identified fault and equipment model.
- The proposed part, compatibility and whether repair is viable.
- Labour, access, consumables and testing included in the work.
- Part availability, expected timing and stated warranty.
- Any separately quoted work required to prevent the fault recurring.
For refrigerant leaks, see leak repair and refrigerant service. For whole-unit options, see AC replacement.
Published by AC Clinic. Updated 21 November 2026. Sources, scope and service standards.